Indication Of The Receiver Radio Channel - Jay Electronique ORION Série Notice Technique D'installation Et D'utilisation

5.9- Reading the current receiver radio channel
The reading of the receiver radio channel number is done from the receiver by
and
JP1 JP2
1- Switch off industrial receiver (ORRA or ORRS), the receiver on DIN rail
(ORRD) can remain power supplied during all the procedure.
2- For the ORRS and ORRA industrial receivers, place jumpers
the short-circuit position (
microswitches
V1 V2 V3
JP1 JP2
JP3
ORRS receiver
3- "Industrial" type receivers (ORRA and ORRS): switch ON receivers.
4- - and
V2
(red) indicates the tens, «ON» = 10, «OFF» = 0
V2
(green) indicates the units by flashing.
V3
Example :
«OFF», and
V2
«06» (433.600MHz)
5- Switch off industrial receiver (ORRS and ORRA) and remove jumpers
and , or set microswitches
JP2
See list of available radio frequencies (radio channels) in appendix H.
Fr
- 76 -
jumper/microswitch and
JP3
and
JP1 JP2
V1 V2 V3
LEDs indicate the current receiver radio channel number.
V3
flashing 6 times, the current radio channel number is
V3
Gb
and
V2
not short-circuited ), for the ORRD receiver, set
to the «ON» position.
JP1 JP2
JP3
ORRA receiver
and
JP1 JP2
De
LEDs.
V3
JP1
JP1
JP2
JP3
JP4
ORRD receiver
to the «OFF» position (ORRD).
324501F
and in
JP2
OFF ON
V1 V3 V2
JP1
revision02