Procedure : «Standby» Function Time Programming - Jay Electronique UC Notice Technique D'installation Et D'utilisation

6.3.3 Procedure : "Standby" function time
1- Switch off the receiver.
2- Insert the electronic key in the transmitter unit.
3- Holding buttons n°1 and n°3 pressed, unlock the stop palmswitch button on the
transmitter (fig.1).
The "Standby" time is displayed by two flashing indicator lights on the transmitter
representing the tens (red) and the units (green) of the number of minutes.
4- Select the new time using buttons n°1 and n°2 (fig.2&3).
Press button n°1 to increment the tens and button n°2 to increment the units.
During these operations, the new time selected is displayed by the two indicator
lights on the transmitter.
5- Once you have selected the desired "Standby" time (between 01 and 99),
press the «On/Horn» button to validate your selection (fig.4).
Caution: No. 99 corresponds to an infinite "Standby" time
> This function is then deactivated and forgetting that the transmitter is
stopped (by pressing the stop palmswitch button) will result in complete
discharge of the transmitter..
6- Exit the "Standby" time programming mode by pressing the stop palmswitch
button (fig.6).
n°5 n°6
n°3 n°4
n°1 n°2
n°4
n°3
n°2
n°1
FR
- 8 6 -
programming
(Automatic shutdown of transmitter)
+10
mn
Fig.1
DATA
Fig.4 Fig.5
EN DE
n°3 n°4
n°2
n°1
Fig.2 Fig.3
Electronic
key
memory
Fig.6
+1
n°3 n°4
mn
n°1 n°2
n°1 n°2
UC 323882G