Procedure : Programming The Working Radio Frequency - Jay Electronique UC Notice Technique D'installation Et D'utilisation

6.3.2 Procedure : working radio channel programming
1- Switch on the receiver.
2- Insert the electronic key in the transmitter unit.
3- Holding buttons n°1 and n°2 pressed, unlock the stop palmswitch on the transmitter
(fig.1).
The radio channel already selected is indicated by two flashing indicator lights on the
transmitter which represent the tens (red) and units (green).
4- Select the new channel using buttons n°1 and n°2 (fig.2&3).
Press button n°1 to increment the tens and button n°2 to increment the units.
During these operations, the newly selected channel is displayed by the 2 indicator
lights on the transmitter which flash accordingly.
5- Once the desired channel is selected (between 01 and 64 or 01 and 12), press the
"On/Horn" button to validate your selection (fig.4).
Briefly pressing "On/Horn" button : the transmitter sends the selected radio channel
number to the receiver and saves its new working radio channel (fig. 5).
By pressing and holding the "On/Horn" button (3 seconds) : the transmitter sends
the selected channel number to the receiver (on each of the radio link channels)
and saves its new working channel. Wait until the transmitter indicator lights no
longer flash (around 30 seconds) (fig. 5)
(this longer procedure is preferable and should be performed when you are not familiar
with the initial working channel of the receiver).
6- Exit the "frequency" programming mode by pressing the stop palmswitch button (fig.6).
7- Check that the receiver has changed channel by performing the startup procedure
detailed in § 6.2.
n°5 n°6
n°3 n°4
n°1 n°2
n°3 n°4
n°1 n°2
UC 323882G
+10
Fig.1
n°5 n°6
n°3 n°4
n°1 n°2
Fig.4 Fig.5
n°3 n°4
n°2
n°1
Fig.2
DATA
DE
n°3 n°4
n°1 n°2
Fig.3
n°2
n°1
Fig.6
EN FR
+1
-85-