Bluetooth® Interface - Bosch GLM 50-27 CG Professional Notice Originale

40 | English
Digital laser measure
Max. transmission power
A) For measurements from the front edge of the measuring tool, this applies for high reflectivity of
the target (e.g. a white-painted wall), weak backlighting and 25 °C operating temperature. In ad-
dition, a deviation of ±0.05 mm/m must be taken into account, depending on the distance.
B) For measurements from the front edge of the measuring tool, this applies for high reflectivity of
the target (e.g. a white-painted wall), strong backlighting and 25 °C operating temperature. In
addition, a deviation of ±0.15 mm/m must be taken into account, depending on the distance.
C) After user calibration at 0 ° and 90 °; An additional grade error of ±0.01 °/degree to 45 ° (max.)
has to be taken into account. The left-hand side of the measuring tool serves as the reference
level for grade measurement.
D) At an operating temperature of 25 °C
E) In continuous measurement mode, the max. operating temperature is +40 °C.
F) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
G) Bluetooth® deactivated
H) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® tools must support the GATT profile.
The serial number (11) on the type plate is used to clearly identify your measuring tool.
Bluetooth® interface
Transmitting data to other devices
The measuring tool is fitted with a Bluetooth® module which enables wireless data trans-
fer to certain mobile devices with a Bluetooth® interface (e.g. smartphone, tablet).
Information about the system requirements for a Bluetooth® connection can be found on
the Bosch website at www.bosch‑pt.com
Further information can be found on the Bosch product page.
u
When transmitting data by means of Bluetooth®, time lags may occur between the mobile
device and the measuring tool. This can be due to the distance between the two devices
or the measurement object itself.
Activating the Bluetooth® interface for transmitting data to a mobile device
Ensure that the Bluetooth® interface is activated on your mobile device.
Press the (1) button to bring up the Bluetooth® menu and press the (1) button again (or
the (6) [+] button), to activate the Bluetooth® interface. If multiple active measuring
tools are found, select the appropriate measuring tool using the serial number. You can
find the serial number (11) on your measuring tool's type plate. The connection status
and the active connection (b) are displayed in the status bar (h) of the measuring tool.
1 609 92A 4ZJ | (14.10.2020)
GLM 50-27 CG
8 mW
GLM 50-27 C
8 mW
Bosch Power Tools