Bluetooth® Interface - Bosch GLM 50 C Professional Notice Originale

OBJ_BUCH-2450-006.book Page 40 Monday, December 18, 2017 12:17 PM
40 | English
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement", see page 35.
Press the button 3 [+]. The calculated area and the symbol "+" will be
displayed.
50.039 m 2
0.0° +93.406 m
2
Press the measuring button 2 [
Measure the area as described in section "Area Measurement", see
143.45 m
2
page 35. Once the second measurement is completed, the result of the
second area measurement is displayed below.To show the end result,
press the measurement button 2 [
Note: With a length measurement, the end result is displayed immediately.
Subtracting Values
To subtract values, press button 8 [–]. The subsequent steps are the same as for
"Adding Values".
Deleting Measured Values
Briefly pressing the On/Off button 5 [
measuring functions. Repeated brief pressing of the On/Off button 5 [
the measured values in reverse order.
Changing the Unit of Measure
Unit of measure "m" (metres) is set by default.
Switch the measuring tool on.
Press and hold button 7 [Func], to enter the "basic configurations" menu. Select
"ft/m".
Press button 3 [+] or button 8 [–], to change the unit of measure.
Press the On/Off button 5 [ ] to exit the menu item. The selected setting remains
saved after you switch off the measuring tool.
Bluetooth® Interface
Data Transmission to other Devices
The measuring tool is equipped with a Bluetooth® module, which enables data trans-
mission via radio technology to certain mobile terminals/devices with a Bluetooth® in-
terface (e.g., smartphones, tablets).
For information on the necessary system requirements for a Bluetooth® connection,
please refer to the Bosch website at
www.bosch-pt.com
1 609 92A 48U | (18.12.17)
] to start another area measurement.
] once more.
] will delete the last measured value in all
] will delete
Bosch Power Tools