Display Illumination; Measuring Functions - Bosch GLM 50 C Professional Notice Originale

Télémètre laser

Masquer les pouces Voir aussi pour GLM 50 C Professional:

Notice originale (30 pages)

Notice originale (570 pages)

Notice originale (335 pages)

Table Des Matières

Table des Matières

Les langues disponibles

OBJ_BUCH-2450-006.book Page 34 Monday, December 18, 2017 12:17 PM

34 | English

Note: If the measuring tool has been switched on using the On/Off button 5 [

briefly press the measuring button 2 [

] to switch the laser on.

To initiate the measurement, briefly press the measuring button 2 [

]. Then the la-

ser beam is switched off. For a further measurement, repeat this process.

 Do not point the laser beam at persons or animals and do not look into the la-

ser beam yourself, not even from a large distance.

Note: The measured value typically appears within 0.5 s and no later than approx.

4 s. The duration of the measurement depends on the distance, the lighting condi-

tions and the reflective properties of the target surface. Upon completion of the

measurement the laser beam is automatically switched off.

Selecting the Reference Level (see figure A)

For the measurement, you can select between three different reference planes:

– the rear measuring-tool edge (e.g. when measuring onward from a wall),

– the front measuring-tool edge (e.g. when measuring onward from a table edge),

– the centre of thread 13 (e.g. for tripod measurements).

To select the reference level, press button 4. Use button 3 [+] or button 8 [–] or but-

ton 4 to select the desired reference level. The rear edge of the measuring tool is pre-

set as the reference level every time the measuring tool is switched on.

"Basic Settings"

To enter the "basic configurations" menu (i) press and hold the button 7 [Func].

Select the respective basic configuration and your setting.

To exit the "basic configurations" menu, press the On/Off button 5 [

] again.