Sawing; Adjusting Nylon Line; After Finishing Work; Transporting - Stihl FSA 130 Notice D'emploi

12 After Finishing Work

► Walk slowly and steadily forwards.

11.4 Sawing

► Support the left side of the deflector against the stem.
► Cut through the stem at full speed.

11.5 Adjusting Nylon Line

AutoCut mowing head
► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced. The line
limiting blade in the deflector trims the mowing lines to the
correct length.
Automatic feed does not operate if the mowing lines are
shorter than 25 mm.
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Press the button on the mowing head and hold it
depressed.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to required length:
Install a new spool with mowing line.
The spool is empty.
0458-726-9921-A
12 After Finishing Work
12.1 After Finishing Work
► Switch off the trimmer, move retaining latch to position
and pull the connecting cable plug out of the socket.
► If the trimmer is wet: Allow the trimmer to dry.
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.

13 Transporting

13.1 Transporting the Trimmer

► Switch off the trimmer, move retaining latch to position
and pull the connecting cable plug out of the socket.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
► Carry the trimmer properly balanced by the drive tube with
the cutting attachment behind you.
► Transporting the trimmer in a vehicle: Secure the trimmer
to prevent it turning over or shifting.

14 Storing

14.1 Storing the Trimmer

► Switch off the trimmer, move retaining latch to position
and pull the connecting cable plug out of the socket.
► Remove metal cutting attachment.
► Remove spool with mowing line and store in a container
filled with water.
The nylon mowing line remains supple.
English
55