Power-Saving Mode - Panasonic CF-VDD285 Mode D'emploi

Setting a Disc
1
Power on your computer
2
Open the disc tray
Press the eject button and slowly pull out the tray.
3
Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks.
<Removing a disc>
Place a finger on the center holder and lift up on the
edge of the disc.
4
Close the disc tray
Close the tray without touching the eject button.
NOTE
If the vibration of the DVD-ROM drive is excessively high, use the Setup Utility to
reduce the CD-ROM or DVD-ROM drive speed by setting it to [Low]. (This setting
does not work for the DVD-ROM disc when using CF-27, CF-28M** and CF-28P**
model.)

Power-saving Mode

If the DVD-ROM Drive Pack has not been accessed within 90 seconds, the drive motor will
automatically shut down to reduce the power consumption. When the DVD-ROM Drive
Pack is accessed once again, the power of the drive motor is turned on. However, approxi-
mately 30 seconds are required until data is actually read from the disc.
Label side up
Eject Button
Center Holder
E
7