Mounting With Floating Target - Balluff BMP 01-EL1PP 1A 00-P S75 Série Notice D'utilisation

BMP 01-EL1PP _ 1A- _ _ _ _ -00 -P _ _ /P _ _ -S4/P _ _ -S75
Magnetic Field Positioning System
4
Installation and connection (continued)
4.3

Mounting with floating target

For mounting with a floating target, mounting screws are
required (see accessories on page 30).
For magnets a field strength of 3...50 mT
(on the mounting surface along the direction of
motion of the magnet) must be ensured.
Distances and tolerances to be observed
To guarantee function, the following distances for the
target must be observed:
BMP
12±2
Fig. 4-11: Distances and tolerances, shown using an example of a
round magnet target Ø10×10 mm with remanence B
~360 mT
Hole spacing
Hole spacing = Measuring range + 2 mm (hole pattern
tolerance = ±0.05 mm)
Example: Measuring range 128 mm
Hole spacing = 130 mm ±0.05 mm
12 english
Direct and inverse mounting
The BMP can be mounted directly (sensing surface
pointing to mounting surface) or inversely.
Target
Fig. 4-12: Installation with floating target (inverse mounting), axially
polarized target (example, N and S can also be swapped)
For inverse mounting, a recess for the button
and the LEDs must be provided (for dimensions,
see Fig. 4-13); otherwise, the BMP can only be
configured via IO-Link.
2.7
R
1.4
Fig. 4-13: Dimensions and distances of the button and LEDs
1. Provide boreholes (distances depend on type; see
Fig. 3-1 on page 7 and Hole spacing on
page 12).
2. Attach the BMP to a surface using mounting screws
(see Accessories on page 30) and a torque of
0.1 Nm.
S
N
Ø 8
6.9
17.8