Accessories - Leister WELDPLAST S4 Instructions D'utilisation

Accessories

• For security and technical reasons, only Leister accessories may be used.
Stand
• The universal tool stand can be used for the following extruder lines:
Fusion 3; Weldplast S4; Weldplast S6
• The hood (37) is swivelled upwards for pre-heating the welding shoe.
• To adjust the stand, loosen the screws in the base and adjust the base
plates (38) to the tool markings.
• The two sliders (40) allow the width to match the required tool.
• The reel holder (39) serves to hold the reels of welding rod ø 300 mm.
• To ensure optimal rod dispensing, the welding rod should be passed through
the eyelets (41) provided.
Transportable welding rod de-reeler
• The de-reeler is designed for rolls of welding rod with Ø 300 mm.
• To ensure that the filler rod is unwound as smoothly as possible, it should be
fed through the specially designed eyes (41).
Hot - air tube on top
• The hot air tube is especially suited for
landfill sites.
Welding shoe range (with external air duct)
• Leister Technologies AG offers the right welding shoes for all common types of seam in various sizes:
Blank V Seam Fillet weld Overlap seam
37
39
38
Corner seam Corner seam
outside short
40
41
41
Corner seam
long
29