Troubleshooting; Technical Specifications - Nilfisk Retriever 6250 Mode D'emploi

TROUBLESHOOTING

If the possible causes listed below are not the source of trouble, it is a
symptom of something more serious. Contact your Nilfisk-Advance
Service Center immediately for service.
TRIPPING THE CIRCUIT BREAKERS
The circuit breakers are located on the Circuit Breaker Panel (33), they
protect electrical circuits and motors from damage due to overload
conditions. If a circuit breaker trips, try to determine the cause.
Shaker Motor Circuit Breaker (8 Amp) Possible causes may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
2 Overloaded or jammed shaker motor (check shaker motor)
Accessory Circuit 1 Circuit Breaker (15 Amp) Possible cause may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
Ignition Circuit Circuit Breaker (15 Amp) Possible cause may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
Horn Circuit Breaker (10 Amp) Possible cause may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
Headlight / Tail Light Circuit Breaker (20 Amp) Possible cause may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
Main Circuit Breaker (40 Amp) Possible cause may be:
1 Electrical short circuit (have your Nilfisk-Advance Service Center or
qualified electrician check the machine)
Once the problem has been corrected, push the button in to reset the
circuit breaker. If the button does not stay in, wait 5 minutes and try
again. If the circuit breaker trips repeatedly, call your Nilfisk-Advance
Service Center for service.
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model
Model No.
Sound Power Level (ISO 3744)
Total Weight
Tire Pressure
Vibrations at the Hand Controls
Vibrations at the Seat
Gradeability
Retriever
™
56419501 / 56419503
dB(A)/20µPa
lbs/kg 4,201 / 1,905
psi
m/s <2.5 m/s
2
m/s <0.5 m/s
2
26.8% (15
TROUBLESHOOTING
If the possible causes listed below are not the source of trouble, it is a
symptom of something more serious. Contact your Nilfisk-Advance
Service Center immediately for service.
MACHINE WILL NOT MOVE
Possible causes may be:
1 Parking Brake (3) set (release parking brake)
2 Towing Valve in wrong position (set correctly)
3 Tripped circuit breaker(s) (reset any tripped circuit breakers)
MAIN BROOM WILL NOT RUN
Possible causes may be:
1 Hopper door is not open (open hopper door)
2 Debris wrapped around the broom drive (remove debris)
3 Hopper is not completely down (lower hopper completely)
4 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SIDE BROOM WILL NOT RUN
Possible causes may be:
1 Hopper door is not open (open hopper door)
2 Debris wrapped around the broom drive (remove debris)
3 Hopper is not completely down (lower hopper completely)
4 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER WILL NOT RAISE
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
HOPPER DUMP DOOR WILL NOT OPEN
Possible causes may be:
1 Dump door jammed by debris (remove debris and clean edges of dirt
chamber)
2 Tripped circuit breaker(s) (reset any tripped circuit breakers)
SHAKER MOTOR WILL NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
DUST CONTROL SYSTEM (IMPELLER) WILL
NOT RUN
Possible causes may be:
1 Tripped circuit breaker(s) (reset any tripped circuit breakers)
6250 / SR 1800H Retriever
™
Petrol
56419500 / 56419502
85
4,201 / 1,905
90
<2.5 m/s
2
<0.5 m/s
2
) 26.8% (15
0
FORM NO. 56041573 - Retriever
ENGLISH / A-19
6250 / SR 1800H Retriever
™
LPG Diesel
56419422 / 56418007
85
4,201 / 1,905
90
<2.5 m/s
2
<0.5 m/s
2
) 26.8% (15
0
6250 / SR 1800H - A-19
™
6250 / SR 1800H
85
90
2
2
)
0