Imeans Of Joining - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
If the corner is
opened towards
inside.
If you get this result : it means your cutting angle is less than 45°.
Your cutting machine needs to be set to the right 45° angle (check your cutting
machine's user manual to make this adjustment).
3.I MEANS OF JOINING
Thanks to the color code, you can recognize and select easily the type of wedges to be
used. Please note that hard wood Vnails will have a yellow pusher to help identifying
them. A white pusher will indicate soft wood wedges.
See color chart bellow for identification.
Cassese wedges can also be supplied in MDF type dedicated to MDF or very hard wood
use. They are identified by a red pusher ine the cartridge.Please contact your local
agent to try them.
It is recommended to use the proper type of wedges for joining, always using hard wood wedges in
all your frame will result in poor tightening of the corner when the wood is soft. A first approach
consists in trying to scratch the wood with your nails, if you can scratch it easily, then a soft wood
wedge should do the job perfectly and you will get the best tightening.
Loosen
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against the
fences again.
Figure 3-21
the
to
by
back
MACH 1 CART
Figure 3-22
Figure 3-23
Figure 3-24
17