Aair Line Fittings; Bconnecting To The Air Source - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting.
2.A AIR LINE FITTINGS
Quick
release(Q/R)
Female
Air Connector
- Z749
Quick
release(Q/R)
Female
2.B CONNECTING TO THE AIR SOURCE
Air Connector
- Z749
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using the quick
connectors as
mentioned in
chapter I.2.A
The red knob in Figure 2-9 must be used to secure the machine during maintenance or to prevent non
desired use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air
from the machine circuit and disconnect it from air supply, but it WILL NOT switch off electrical components.
Refer to chapter I.5.A
If the indicated pressure is not 6 bars (85 p.s.i.), check the pressure at the air source (compressor). Then, if pressure is correct at
the air source, it means the regulator of the machine needs fine tuning. Perform the following procedure to adjust it (Figure 2-10
and Figure 2-11)
Included in the machine
Standard hose connector - Z556
Q/R US male connector - Z701
Figure 2-8
SAFETY INSTRUCTIONS
Customer's air connection
The MACH 1 CART
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob .
The air pressure
gauge should show 6
bars (85 p.s.i.)
minimum.
(page 21) for further instructions.
MACH 1 CART
Figure 2-9
11