Eproper Adjustment Of Magnetic Adjustable Rod Clamp - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
Switch back off the
Pre-Clamp button in
order to release the
mouldings and
remove the
moulding that was
against the back
fence.
3.E PROPER ADJUSTMENT OF MAGNETIC ADJUSTABLE ROD CLAMP
A magnetic
adjustable rod
clamp comes with
your machine as a
standard feature.
It fits the crossbar
thanks to the
locking ring and
can be set at 1 to 7
positions.
When adjusting the vertical rod clamp, closer it is from the top of the moulding, and faster will be
the machine. The machine will not damage the moulding, even if the distance is very close. If the
distance is superior to 50mm, the wedge will not penetrate fully inside the wood.
Pay attention to
properly position the
magnetic chevron
clamp: the sides of
the chevron must be
parallel to back
fences 1 and 2.
Figure 3-12
Pull the black knob
to be able to adjust
the space between
the vertical
and the top of the
moulding. You must
have 50mm (2") max
between the clamp
and the top of the
moulding.
Figure 3-13
Example
setting
chevron.
Figure 3-15
clamp
of bad
of the
MACH 1 CART
Figure 3-14
Figure 3-16
15