Fselecting The Wedges Positions; Gthree Essential Rules; Hadjusting The Joining Angle - Cassese MACH 1CART Manuel D'utilisation

USER MANUAL
Now with quick-
change magnetic
clamps, it is easy to
change from chevron
to a round clamp.
Simply pull down the
Z24703 to change of
clamp support.
3.F SELECTING THE WEDGES POSITIONS
The MACH 1 CART is designed to join mouldings in 1 to 9 positions. You can stack up to 9 wedges in each position. The selection
depends on the width and thickness of the moulding to join.
3.G THREE ESSENTIAL RULES
1- A MINIMUM 2 mm clearance (less than 1/8") above the wedges shall be
respected.
2- Same size wedges can be stacked up in order to avoid having to change the
wedge size when joining mouldings with different thickness.
3- The wedge positions should be lined up to the highest points of the moulding.
When selecting the position of the top clamp, always pay attention to its contact surface with the
moulding. Select positions that will provide steady seating.
3.H ADJUSTING THE JOINING ANGLE
If the corner is
opened towards
outside
Figure 3-17
Tighten
adjusting screw
correct the defect of
the mouldings.
Check the quality of
the angle
clamping the corner
against
fences again.
Figure 3-19
the
to
by
the back
MACH 1 CART
Figure 3-18
Figure 3-20
16