Operation - Dometic SKYSCREEN POWERED Instructions De Montage Et De Service

Skyscreen Powered
7.2 Frame fitting
A
NOTICE! Risk of damage
• Use packing material where required (fig. 3, page 4). The side tracks must
be perpendicular to the head rail.
• Use screws and plugs suitable for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.
• Ensure not to drill through the wall.
Proceed as shown (fig. 4, page 4):
➤ Align the blind with the window cut-out and mark where the holes are to be
drilled for the frame.
➤ Fix the frame with the screws to the ceiling.
I
NOTE
Check whether the moving rail is square and moves freely. If the moving rail is
not square it can be adjusted as shown (fig. 9, page 7 to fig. b, page 8).
➤ If necessary, you can remove a panel as shown (fig. 9, page 7 and fig. 0,
page 7 for installations without headlining or fig. a, page 8 for installations
with headlining).
7.3 Cover fitting (optional)
➤ Proceed as shown (fig. 5, page 5).
8

Operation

A
NOTICE! Risk of damage while driving
Only for boats and yachts: If the blind is fitted beneath an open sunroof,
then the blind should be stowed when driving at more than 10 knots or with a
sea state of more than moderate, because this can damage the blind. Parts that
come loose may injure people in the vicinity.
I
NOTE
• When operating the blind using switches or an automation
system: If the movement direction is reversed too quickly, the motor might
not detect the polarity change and will just stop. To prevent this, the power
must be off for at least 0.5 seconds before the movement direction is
reversed.
• When the motor is stopped the power consumption falls to 8.5 mA. After
approximately 4 minutes the motor automatically switches off.
EN
Operation
17