Binding; Changing The Throttle Limit; Getting Started - ECX RUCKUS TORMENT Mode D'emploi

EN

BINDING

Binding is the process of programming the receiver to recognize the GUID
(Globally Unique Identifier) code of a single specific transmitter. The
STX2™ and SPMSRX200 receiver are bound at the factory. If you need to
rebind, follow the instructions below.
1. With the vehicle on a flat, level surface, insert the Bind Plug in the
BIND port on the receiver.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The red LED flashes, indicating the receiver is
in bind mode.
4. Center the ST TRIM and TH TRIM dials on the transmitter.
5. Turn the steering wheel to Full Right. Power the transmitter on
while holding the steering wheel to the Right.
6. Release the steering wheel when the receiver LED stops flashing.

GETTING STARTED

1. Power on the transmitter.
3. Perform a test of the transmitter's control of the vehicle
with the vehicle's wheels off the ground.
2.4GHZ DIGITAL
RADIO SYSTEM
RUCKUS | TORMENT | K&N TORMENT
6
®
7. Remove the Bind Plug, then power off the receiver to save the
settings.
8. Power off the transmitter.
9. Remove the bind plug and store it in a convenient place.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle or
steering reversing has been changed.
• Binding the receiver to a different transmitter.

CHANGING THE THROTTLE LIMIT

The throttle limit switch enables you to limit the full throttle position
without adjusting the throttle travel adjustment.
Move the throttle limit switch to 50% or 75% for less experienced drivers
or when you are driving the vehicle in a small area.
When you move the Throttle Limit switch to 100%, the full throttle
position is equal to the high Throttle Travel position.
2. Power on the ESC.
4. Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
IMPORTANT: Seat the motor brushes by driving smoothly on a flat
surface during use of the first battery charge. Properly seating the motor
brushes will increase the life and performance of the motor.
™
Throttle Limit Switch
™