Connecting The Cables - Epson TM-H2000 Manuel De L'utilisateur

Unpacking
Check whether the following items are included. If any item is damaged, contact
your dealer.
❏
Printer
❏
Ribbon cartridge (ERC-43)
❏
Power switch cover
❏
AC cable*
* May not be included depending on the printer model.

Connecting the Cables

CAUTION:
For a serial interface, use a null modem cable.
For a parallel interface, use an IEEE 1284 cable.
For a USB interface, do not turn on the printer before installing the printer driver.
Note:
Available interfaces vary by the printer model. For the positions and shapes of the
connectors, see illustration B.
The customer display is available only when using a serial interface or USB interface
located at the position shown as 15 in illustration B.
1. Make sure the power switch is off.
2. Connect the power cord to the printer.
3. Connect each interface cable to the printer. When using the USB interface, fix
the USB cable with the cable hook to prevent the USB cable from coming off.
(See illustration D.)
4. Connect the interface cable to the computer.
5. Insert the power cord plug into a socket.
Installing and Removing the Connector Cover
To install the included connector cover, follow the steps below.
1. Align 2 projections on the top of the connector cover (indicated as a in
illustration E) with holes in the back of the printer.
2. Push the connector cover forward so that the projections at the bottom of the
printer (indicated as b in illustration E) fit properly in the holes in both sides
of the connector cover.
To remove the connector cover, push both sides of the cover inward to remove the
holes in both sides of the cover from the projections at the bottom of the printer
(indicated as b in illustration E).
❑
Thermal roll paper (for operation check)
❑
Connector cover
❑
AC adapter*
❑
User's manual (this manual)
TM-H2000 User's Manual 11
English