Epson TM-H2000 Manuel De L'utilisateur page 12

English
Installing and Replacing the Ribbon Cartridge
Follow the steps below to install/replace the ribbon cartridge for the endorsement
printer.
Note:
Use the EPSON ERC-43 ribbon cartridge.
1. Turn on the printer.
2. Pull the lever on the left side of the receipt unit to open the receipt unit. (See
illustration F.)
3. Remove the used ribbon cartridge, if there is one.
4. Turn the knob on the ribbon cartridge a little in the direction of the arrow
marked on the cartridge to remove any slack in the ribbon. (See
illustration G.)
CAUTION:
Make sure to note the direction of the arrow marked on the ribbon
cartridge when turning the knob. If it is turned in the reverse direction, the
cartridge may be damaged.
Insert a new ribbon cartridge until it clicks into place. (See illustration H.)
5.
6. Turn the knob on the cartridge in the marked direction again to remove any
slack in the ribbon.
7. Close the receipt unit.
Installing and Replacing the Franking Cartridge
Installing an optional franking cartridge enables you to stamp a phrase in red ink
on the front of each check to distinguish processed checks from unprocessed ones.
CAUTION:
Use the optional EPSON EFC-02 franking cartridge.
Keep the franking cartridges out of the reach of children.
Be careful during handling, because the ink can permanently stain clothing.
Do not remove the franking cartridge from the packing box until immediately
before its installation. Leaving the cartridge out of its packing for a prolonged
period of time may adversely affect printing quality.
Use up the franking cartridge within 18 months from the date of production
indicated on the cartridge box.
Dispose of the franking cartridge in accordance with any relevant national or
local laws, ordinances, and regulations.
1. Turn on the printer.
2. Open the front cover using the tabs on both sides of the front cover. (See
illustration I.)
3. Remove the used franking cartridge, if there is one, and insert a new franking
cartridge so that the hole in the franking cartridge is aligned with the
projection on the franking unit. (See illustration J.)
4. Close the front cover.
12 TM-H2000 User's Manual