Loading Paper; Test Printing - Epson TM-H2000 Manuel De L'utilisateur

Loading Paper

CAUTION:
Be sure to use the specified roll paper.
Do not insert any paper that has clips or staples. This may cause paper jams
and damage.
Make sure the slip paper is flat, without curls, folds, or wrinkles.
Note:
Use personal checks of 12 cm {4.7"} long or more.
Installing and Replacing the Roll Paper
Follow the steps below to install/replace the roll paper. (See illustration L.)
1. Turn on the printer.
2. Open the roll paper cover using the tabs on both sides of the roll paper cover.
3. Remove the used roll paper core, if there is one, and insert the roll paper in
the correct direction.
4. Pull out some paper, and close the roll paper cover.
5. Tear off the paper with the manual cutter.
Inserting Slip Paper
When printing on slip paper or reading MICR characters, follow the steps below
to insert the paper. (See illustration K.)
1. Turn on the printer.
2. Insert the paper face up with the right paper edge against the right side of the
paper guide as far as it will go. To read MICR characters, make sure the MICR
characters on the check paper are on the right side.
3. Insert the paper straight until the top edge of the paper touches the stopper.
4. When the printer starts feeding the paper, release it immediately.
5. Pull the ejected paper straight up out of the printer.

Test Printing

After the printer setup or when the printer is not operating correctly, you can
check the printer operation with test printing. If the printer performs pattern
printing following the steps below, the printer is operating normally.
Test Printing on Roll Paper
Make sure all the covers are closed, and while pressing the Feed button, turn on
the printer. After the printer prints its status and the Paper LED flashes, press the
Feed button again to restart the test printing.
Test Printing on Slip Paper
Make sure all the covers are closed, and while pressing the Release button, turn
on the printer. After the Slip LED flashes, insert the slip paper.
Both types of test printing are completed when "*** completed***" is printed.
TM-H2000 User's Manual 13
English