Connecting Cables - Epson TM-L90 Manuel D'utilisation

Connecting Cables

1. Place the printer as shown in illustration
direction of the arrow in the illustration to remove the cover.
2. Break off by hand any of the three portions indicated by circles in
illustration
3. Connect the cables to the printer.
4. Attach the cover while passing the cables through the holes.
Installing or Replacing the Roll Paper
CAUTION:
Be sure to use roll paper that meets the specifications.
If you change the paper type from linerless label paper to thermal roll paper, cleaning
around the paper path is recommended. (See "Cleaning Inside the Printer" on page 11.)
1. Open the roll paper cover using the cover open lever. (See illustration
2. Remove the used roll paper core if there is one.
3. Insert a roll of paper in the correct direction. (See illustration
4. Pull out a small amount of paper, aligning the paper with the paper
guides on both sides. (See illustration
5. Close the roll paper cover.
When the printer is powered on, the paper will feed and cut
automatically.
Note:
Be sure to close the roll paper cover completely by pushing on the middle
of the cover.
10 TM-L90 User's Manual
to pass the cables through.
G
, and pull the cover in the
F
I.)
B.)
H.)