Connecting To A Power Source; Connecting To External Devices - Epson TM-T88V-i Manuel De L'utilisateur

Connecting to a Power Source

Note:
It takes approximately 30 seconds after the printer is turned on until it is ready for
printing.
Use the power switch on the front of the printer to turn the printer on and off.
Make sure the power switch is turned off, and connect the dedicated AC adapter
to the printer, as shown in illustration A on page ii.

Connecting to External Devices

CAUTION:
When connecting external devices to the USB (including Micro-USB)
connectors, follow the precautions below.
• Confirm the rated current of the external devices by checking the
descriptions on the devices or manuals. Do not use a device whose
rated current is unclear.
• Use the UL-approved external devices (only for North American users).
• Connect the external devices only when those total rated current is less
than 2.0 A.
When using the printer, make sure the protective cover indicated in the
illustration below fits firmly into place.
When LAN cables are installed outdoors, make sure devices without proper
surge protection are cushioned by being connected through devices that do
have surge protection. Otherwise, the devices can be damaged by lightning.
Note:
Connecting the optional Wireless LAN Cable Set (OT-WL01) to the USB connector
enables the wireless LAN connection. While connecting via wireless LAN, keep the
Ethernet cable unconnected to the printer.
1. Connect each cables to the connectors at the back of the printer. See the
illustration below for the positions of the connectors.
Ethernet
connector
USB connectors
(for optional products)
Note: Connectors marked "❋" above are not available currently.
2. Connect other ends of the cables to external devices.
Drawer kick-out connector
Analog RGB
connector ❋
Protective cover
Micro SD card
slot ❋
USB connector
(for optional
products)
Micro-USB (Type AB)
connector (for setting only)
TM-T88V-i User's Manual 5
English