Epson TM-T88V-i Manuel De L'utilisateur page 12

English
Attaching the Connector Cover
Follow the steps below to attach the connector cover to protect the cables.
Note:
The connector cover has 3 cable exits in different directions. When pulling out the cables
whose connector does not lock itself (USB cable and DC 5 V cable) from the cable exits on
the back, fix the cables with the cable band to prevent the cables from coming off. (See
illustration B on page ii.)
1. Turn over the printer.
2. Position the two hooks on both sides of the connector cover so that they hook
the printer case, as shown in illustration D.
3. Push the connector cover to click onto the printer case, as shown in
illustration D.
4. Pass each cable through the cable exits at the bottom of the connector cover.
If the cables are too many for one cable exit, use multiple exits.
5. Turn over the printer, and make sure the cables are not pinched. (See
illustration C.)
To remove the connector cover, turn the printer over, and push the connector
cover down while pushing both sides of the connector cover inward to detach the
hooks from the printer case. See illustration E.
Installing Roll Paper
Follow the steps below to install roll paper. If you want to change the paper width
by using the roll paper guide, see "Changing the Paper Width" on page 7.
1. Press the cover open button to open the roll paper cover. (See illustration F.)
2. Remove the used roll paper core if any, and insert the roll paper in the correct
direction. See illustration G on page iii.
3. Pull out some paper, and close the roll paper cover, as shown in illustration H.
4. Tear off the paper, as shown in illustration I.
6 TM-T88V-i User's Manual