Electromagnetic Fields (Emf); Preparing For Use; Baby Unit; Mains Operation - Philips AVENT SCD520 Mode D'emploi

EngliSh
8

Electromagnetic fields (EMF)

This Philips AVENT appliance complies with all standards regarding electromagnetic fields (EMF).
If handled properly and according to the instructions in this user manual, the appliance is safe to use
based on scientific evidence available today.

Preparing for use

Baby unit

You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to
use the unit from the mains, we advise you to insert the non-rechargeable batteries. This guarantees
automatic back-up in case of mains failure.

Mains operation

1 Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. ).
The power-on light goes on.
,
operation on non-rechargeable batteries
The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries (Fig. ).
 Insert four non-rechargeable batteries (Fig. ).
Note: Make sure the + and - poles point in the right direction.
 Reattach the lid (Fig. 5).
Note: When the batteries are low, the battery light on the baby unit flashes red.
Parent unit
operation on rechargeable batteries
The parent unit comes with two rechargeable NiMH AAA 900mAh batteries.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the
batteries are low (the empty battery symbol flashes on the display and the parent unit beeps).
The parent unit starts indicating that the batteries are low 30 minutes before the batteries are
completely empty.
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1 Remove the lid of the compartment for the rechargeable batteries (Fig. 6).
 Insert the rechargeable batteries (Fig. ).
Note: Make sure the + and - poles of the batteries point in the right direction.
 Reattach the lid (Fig. 8).
 Insert the small appliance plug into the charger, put the adapter in a wall socket and place the
parent unit in the charger (Fig. 9).
The charging light on the charger goes on.
,
The display shows a charging battery symbol to indicate that the parent unit is charging.
,