Compliance With Standards; Electromagnetic Fields (Emf); Preparing For Use - Philips AVENT SCD506 Mode D'emploi

English
8
- Do not install the appliance near any heat sources such as radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce heat.
- Make sure that your hands are dry when you handle adapters, plugs and mains cord and also
when you insert or replace disposable and rechargeable batteries.
- All the required markings are located on the battery compartment of the parent unit and baby unit
and on the bottom enclosure of the charger (if any).
- For the parent unit, only use the rechargeable battery supplied with the baby monitor.
- Charge the rechargeable battery as described in the user manual.
- The parent unit can only be recharged with the rechargeable battery supplied.
- To prevent battery explosion or leakage, which can damage the baby monitor and cause burns and
skin or eye irritation:
-
Do not recharge non-rechargeable batteries in the parent unit.
-
Remove rechargeable and disposable batteries if you are not going to use the baby monitor for
more than 30 days.
-
Make sure the + and - poles of the batteries point in the right direction.
-
Keep the batteries away from excessive heat such as sunshine, fire or the like.
-
Do not leave empty batteries in the baby unit.
- To prevent batteries from heating up or releasing toxic materials, hydrogen or oxygen, do not
overcharge, short-circuit, reverse charge or damage batteries.
- To handle damaged or leaking batteries, wear protective gloves to protect your skin.

Compliance with standards

- This product complies with the radio interference requirements of the European Community (Fig.
3).
- Philips Consumer Lifestyle hereby declares that this baby monitor is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU (DECT: frequency
band 1880-1900 MHz, maximum radio-frequency power: 250 mW). A copy of the EC Declaration of
Conformity (DoC) is available online at www.philips.com/support.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and regulations regarding exposure to
electromagnetic fields.

Preparing for use

Baby unit
We advise you to operate the baby unit from the mains. To guarantee automatic power backup in
case of mains failure, you can insert four 1.5V AA alkaline batteries (not included).
Do not use rechargeable batteries. The baby unit does not have a charging function and rechargeable
batteries discharge slowly when they are not in use.
1 Remove the lid of the battery compartment (Fig. 4).
2 Insert four non-rechargeable 1.5V R6 AA batteries. Make sure that the + and - poles point in the
right direction (Fig. 5).
3 Reattach the lid.
4 Put the small plug in the baby unit and put the adapter in the wall socket (Fig. 6).