Warranty And Support; Frequently Asked Questions - Philips AVENT SCD506 Mode D'emploi

Warranty and support

If you need information or support, please visit www.philips.com/support or read the international
warranty leaflet.
Recycling
- This symbol means that this product shall not be disposed of with normal household waste
(2012/19/EU) (Fig. 25).
- This symbol means that this product contains rechargeable and disposable batteries which shall
not be disposed of with normal household waste (2006/66/EC) (Fig. 26).
- Follow your country's rules for the separate collection of electrical and electronic products, and
rechargeable and disposable batteries. Correct disposal helps prevent negative consequences for
the environment and human health.
Removing rechargeable and disposable batteries
To remove rechargeable and disposable batteries, see the instructions for placing and/or removing
batteries in the user manual.

Frequently asked questions

Question
Why don't the power-on light
of the baby unit and the 'link'
light of the parent unit light up
when I press the on/off
buttons of the units?
Why doesn't the battery status
light on the parent unit light
up when I start recharging the
parent unit?
Is my baby monitor secure
from eavesdropping and
interference?
Why does the parent unit
beep?
Answer
Perhaps the rechargeable battery of the parent unit is empty and
the parent unit is not plugged in. Put the small plug in the parent
unit and put the adapter in a wall socket. Then press the on/off
button to establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty
and the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then
press the on/off button to establish connection with the parent unit.
It takes a few minutes before the battery status lightlights up,
especially when the parent unit is charged for the first time or has
not been in use for a long period.
The DECT technology of this baby monitor guarantees no
interference from other equipment and no eavesdropping.
If the parent unit beeps while the 'link' light fashes red, the
connection with the baby unit is lost. Move the parent unit closer to
the baby unit to re-establish the connection between the parent
unit and the baby unit.
If the parent unit beeps and the battery status light flashes red,
recharge the parent unit.
If the baby unit is switched off, switch on the baby unit.
English
13