Lullaby Function - Philips AVENT SCD506 Mode D'emploi

English
10
-
If no connection is established, the 'link' light flashes red and the parent unit beeps from time to
time.
Note: It takes less than 15 seconds to establish the link between the parent unit and the baby unit.
What to do if no link is established
- If the parent unit is out of range, place it closer to the baby unit, but not closer than 1 metre/3.5
feet.
- If the baby or parent unit is too close to another DECT appliance (e.g. a cordless phone), switch off
this appliance or move the unit away from this appliance.
- If the baby unit is switched off, switch it on.
Operating range
- The operating range is 330 metres/1000 feet outdoors and up to 50 metres/150 feet indoors.
- The operating range of the baby monitor varies depending on the surroundings and factors that
cause interference. Wet and moist materials cause so much interference that the range loss is up to
100%. For interference from dry materials, see the table below.
Dry materials
Wood, plaster, cardboard,
glass (without metal, wires
or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium sheets < 1cm (0.4in)
Functions and feedback on the baby unit
Nightlight
The nightlight produces a soft glow that comforts your baby.
1 Press the nightlight button on the back of the baby unit to switch on the nightlight (Fig. 14).
2 Press the nightlight button again to switch off the nightlight.

Lullaby function

1 Press the lullaby play/stop button on the baby unit to play the last selected lullaby (Fig. 15).
The selected lullaby repeats for 30 minutes.
2 Press the next lullaby button to select another lullaby from the list (Fig. 16).
3 To adjust the sound level of the lullaby, press the + or – button on the baby unit.
4 To stop lullaby playing, press the lullaby play/stop button on the baby unit.
Material thickness
< 30cm (12in)
< 30cm (12in)
< 30cm (12in)
< 1cm (0.4in)
Loss of range
0-10%
5-35%
30-100%
90-100%
100%