Philips AVENT SCD506 Mode D'emploi page 14

English
14
Question
Why does the parent unit
produce a high-pitched noise?
Why don't I hear a sound/ Why
can't I hear my baby cry?
Why does the parent unit react
too quickly to other sounds?
Why does the parent unit react
slowly to the baby's crying?
Why do the non-rechargeable
batteries of the baby unit run
low quickly? How can I save
battery power?
The specific operating range of
the baby monitor is 330
metres/1000 feet. Why does
my baby monitor manage a
much smaller distance than
that?
Why is the operating time of
my parent unit shorter than 24
hours?
Answer
The units may be too close to each other. Make sure that the parent
unit and the baby unit are at least 1.5 metres/5 feet away from each
other. It takes a few seconds for the high-pitched noise to stop.
The volume of the parent unit may be too high. Decrease the
volume of the parent unit.
The volume of the parent unit may be too low or may be switched
off. Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be too low.
Increase the microphone sensitivity level on the parent unit.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
The baby unit also picks up other sounds than those of your baby.
Move the sound sources away from the baby unit.
The microphone sensitivity level of the baby unit may be too high.
Decrease the microphone sensitivity level on the parent unit.
The microphone sensitivity level of the baby unit may be too low.
Increase the microphone sensitivity level on the parent unit.
The ECO Max mode is on and the baby unit only switches on the
DECT signal when the baby makes sounds. Switch off the ECO Max
mode to make the baby unit transmit DECT signals continuously
and to make the parent unit respond more quickly to your baby's
sounds.
The microphone sensitivity level of the baby unit may be too high,
which causes the baby unit to transmit more often. Decrease the
microphone sensitivity level in the menu of the parent unit.
The speaker volume on the baby unit may be too high, which
causes the baby unit to consume a lot of energy. Decrease the
speaker volume of the baby unit.
Perhaps you switched on the nightlight. If you want to use the
nightlight, we advise you to run the baby unit on mains power.
To save energy, activate the ECO Max mode.
The specified range is only valid outdoors in open air.
When the parent unit is charged for the first 4 times, the operating
time is less than 24 hours. The rechargeable batteries only reach the
full capacity after you charge and discharge them at least 4 times.