Using The Appliance; Positioning The Baby Monitor; Operating Range - Philips AVENT SCD520 Mode D'emploi

5 Leave the parent unit in the charger until the batteries are fully charged.
During charging, the charging light on the charger lights up continuously.
,
When the batteries are fully charged, the display of the parent unit shows a full battery
,
symbol T.
- When you charge the parent unit for the first time or after a long period of disuse, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the batteries are fully charged, the parent unit can be used cordlessly for at least 24 hours.
Note: When the parent unit is charged for the first time, the operating time is less than 24 hours.
The batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent
unit is switched off.

using the appliance

1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press and hold the on/off button 3 on the baby unit until the green power-on light goes on
(Fig. 11).
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
The nightlight lights up briefly and then goes out again.
,
The battery light T lights up briefly and then goes out again (Fig. 12).
,
 Press and hold the on/off button 3 on the parent unit until the sound level lights light up
briefly. (Fig. 13)
The display goes on and the battery symbol appears on the display (Fig. 1).
,
The LINK light flashes red and the message 'Searching' appears on the display (Fig. 15).
,
The LINK light on the parent unit turns green and lights up continuously when a connection
,
has been established between the baby unit and parent unit. The message 'Linked' appears on
the display (Fig. 16).
After 2 seconds the message 'Linked' disappears and the temperature value is shown on the
,
display (Fig. 1).
If no connection is established, the LINK light on the parent unit stops flashing and lights up
,
red. The parent unit beeps from time to time and the message 'Not Linked' appears on the
display. (Fig. 18)

Positioning the baby monitor

1 Place the baby unit at least 1 metre/ feet away from your baby (Fig. 19).
 Place the parent unit within the operating range of the baby unit. Make sure it is at least
1 metre/ feet away from the baby unit to avoid acoustic feedback (Fig. 0).
For more information on the operating range, see section 'Operating range' below.

operating range

The operating range of the baby monitor is 330 metres/1000 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is
up to 50 metres/150 feet.
EngliSh
9