Using The Appliance - Philips Avent SCD497 Mode D'emploi

EngliSh
8
Make sure the + and – poles of the batteries point in the right direction.
,
 Slide the battery compartment lid back onto the back of the parent unit until it locks into
position ('click') (Fig. 8).
 Put the small appliance plug in the parent unit and put the adapter in a wall socket (Fig. 9).
5 Leave the parent unit connected to the mains until the batteries are fully charged.
When charging for the first time or after a long period of disuse: switch off the
,
parent unit and let it charge continuously for at least 10 hours.
Charging normally takes 8 hours, but it takes longer when the parent unit is switched on
,
while charging. To keep the charging time as short as possible, switch off the parent unit
during charging.
The battery check light goes out when the batteries are fully charged.
,
When the batteries are fully charged, the parent unit can be used cordlessly for at least
,
 hours.
Note: The operating time of 24 hours is based on the assumption that the baby unit transmits 25% of
the time and is in standby mode for the rest of the time (when the baby does not make any sound).
Note: When the parent unit batteries are charged for the first time, the operating time is less than 24
hours. The batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the batteries are running low, the battery check light flashes red. Put the small appliance
plug in the parent unit and put the adapter in a wall socket to recharge the batteries.
Note:When the parent unit is not connected to the mains, the batteries gradually discharge, even when
the parent unit is switched off.
mains operation
1 Put the small appliance plug in the parent unit and put the adapter in a wall socket (Fig. 9).

using the appliance

1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
 Press and hold the on/off button 3 on the baby unit for  seconds. (Fig. 11)
The nightlight lights up briefly.
,
The ON light lights up.
,
 Press and hold the on/off button 3 on the parent unit for  seconds. (Fig. 1)
The sound level lights light up blue briefly.
,
The battery check light lights up briefly.
,
The LINK light lights up red briefly and then starts to flash green while the parent unit tries
,
to establish connection with the baby unit.
The LINK light on the parent unit flashes green until connection has been established.
,
This takes up to 0 seconds. The LINK light on the parent unit then lights up
green continuously.
If no link is established after 30 seconds, the LINK light on the parent unit flashes red and the
,
parent unit beeps from time to time.
 Place the baby unit at least 1 metre/ feet away from your baby (Fig. 1).
5 Position the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/ feet away from the baby unit (Fig. 1).
For more information on the operating range, see section 'Operating range' below.