Nightlight; Reset Function - Philips Avent SCD497 Mode D'emploi

EngliSh
10
Note: When the microphone sensitivity of the baby unit is set to a high level, it picks up more sounds and
therefore transmits more often. As a result, the units consumes more power.
Silent baby monitoring
1 Briefly press the volume down (–) button on the parent unit until the volume is switched off
completely (Fig. 19).
The volume is completely switched off when all sound level lights are out.
As long as the baby unit does not detect a sound, all sound level lights on the parent unit are
,
out (Fig. 0).
When the baby unit picks up a sound, one or more sound level lights on the parent unit go
,
on. The louder the sound, the more lights go on.

nightlight

1 Briefly press the nightlight button Q on the baby unit to switch on the nightlight. (Fig. 1)
 Press the nightlight button Q again briefly to switch off the nightlight.
The nightlight dims gradually before it goes out completely.
,
Note: If you press the nightlight button Q too long, the nightlight does not come on or go out.
Tip:Switch off the nightlight when you operate the baby unit on batteries. This saves power.
paging the parent unit
If you have misplaced the parent unit and its volume is switched off, you can use the PAGE button
on the baby unit to locate the parent unit.
1 Briefly press the PAGE button on the baby unit (Fig. 22).
The parent unit automatically resets to medium volume level and produces a paging alert
,
tone.
 To stop the paging alert tone, press the PAGE button again briefly or press any button on the
parent unit.
Note: If you press the PAGE button too long, the parent unit will not produce the paging alert tone.
Belt clip
If the batteries of the parent unit are sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip. This allows you
to monitor your baby while you are moving around.
Connecting the belt clip
1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left () until it locks into position ('click') (Fig. ).
Disconnecting the belt clip
1 Turn the belt clip to the right (1) and take it out of the opening () (Fig. ).

reset function

This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
'Frequently asked questions'. You have to reset each unit separately.
1 Press and hold the on/off button 3 for  seconds to switch on the unit. (Fig. 11)
 Then immediately press and hold the volume down (-) button until the appliance
beeps (Fig. 5).
The unit has now been reset to the default factory settings.
,