Assemble The 3-Tooth Blade; Mount The Spool; Extend The Thread - Parkside PKGA 40-Li A1 Traduction Des Instructions D'origine

GB IE
1. Loosen the screw (48) on the carrying
harness eye with the hexagon socket
wrench (22) and tighten it slightly.
2. Depending on the cutting tool, balance
the tool according to the criteria men-
tioned above by moving the eyelet (6)
along the tube shaft (4).
3. Tighten the screw (48) when the device
is in the desired position.
Assemble the 3-tooth
blade
Whenever you use the 3-too-
th blade, the protective cover
without extension must be
used. (See Chapter: "Remo-
ving/mounting the protective
cover extension")
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (52) using
the hexagon socket wrench (22) as de-
picted.
4. Place the 3-toothed blade onto the
mounting spindle (52). The blade can
be used on both sides.
5. Fasten the blade using the thinner was-
her (53), conical spring washer (54)
and nut (55).
Insert the nut (55) into the conical
spring washer (54) as shown.
Use the assembly key (23) to secure it.
6. Remove the hexagon socket
wrench (22)!
Dismantling is carried out in reverse
order.
54

Mount the spool

The protective cover must be
mounted with the extension
when using the thread spool.
(See Chapter: "Removing/
mounting the protective co-
ver extension")
Do not replace the non-me-
tallic filaments of the spool
end with metallic filaments!
Risk of injury!
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (52) using
the hexagon socket wrench (22) as de-
picted.
4. Place the thin washer (53) on the
mounting spindle (52).
5. Screw the spool cap (17) anticlock-
wise back onto the mounting spindle
(52).
Dismantling is carried out in reverse
order.

Extend the thread

Your device is equipped with a doub-
le-string activated touch control, i.e. the
two strings are extended when you tap the
cutting head on the ground.
1. Hold the device in operation over a
grassy area and lightly tap the cutting
head a few times on the ground. This
causes the thread to lengthen.
2. The protective cover (
into the protective cover (
the thread to the desired length.
15) inserted
A
14) cuts
A