Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY STEP 5
HARdWARE fOR STEP 5 :
BOLT (I)
SPRING WASHER (B)
15 mm
8.2 mm
Qty: 6
Qty: 6
BOLTS (I)
SPRING WASHERS (B)
FLAT WASHERS (E)
14
71AT_OM_Rev1_6.indd 14-15
A
Attach console cables from handlebars
to console cables from console. gently
tuck excess cable into console before sliding the
FLAT WASHER (E)
handlebars onto console.
8.2 mm
Qty: 6
Attach handlebars to console using 6
B
bolts (i), 6 spring washers (b) and 6 flat
washers (e).
CONSOLE
C
Completely tighten all bolts from step 4.
CONSOLE CABLES
HANDLEBARS
NOTE: Do not pinch wires while attaching
the handlebars.
IMPORTANT
This treadmill has a pre-waxed belt and
should never be lubricated. Waxing
the belt can cause damage that is not
covered by the warranty.
YOU ARE FINISHED!
TREADMILL OPERATION
This section explains how to use your treadmill's console and programming. The BASIC OPERATION section in the
TREADMILL gUIDE has instructions for the following:
• lOCATION Of THE TREAdMIll
• USING THE SAfETy kEy
• fOldING THE TREAdMIll
• MOVING THE TREAdMIll
• lEVElING THE TREAdMIll
• TENSIONING THE RUNNING bElT
• CENTERING THE RUNNING bElT
• USING THE HEART RATE fUNCTION
15
8/31/11 1:40 PM
Publicité
Table des Matières
