AFG 7.1AT Manuel Du Propriétaire page 6

ASSEMBLY STEP 1
HARdWARE fOR STEP 1 :
BOLT (A) SPRING WASHER (B)
20 mm
8.2 mm
Qty: 6 Qty: 6
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
10
71AT_OM_Rev1_6.indd 10-11
A Open hardware for step 1.
B Pull lead wire through right console mast.
ARC WASHER (C)
After pulling the lead wire through the mast, the
8.2 mm
top of the console cable should be located at
Qty: 6
the top of the mast. Detach and discard lead wire.
NOTE: Do not pinch console cable when placing
N
the mast onto the main frame bracket.
C Attach console mast to main frame
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
NOTE: Do not tighten bolts until step 3 is complete.
LEAD WIRE
CONSOLE CABLE
D Repeat step C on other side.
ASSEMBLY STEP 2
HARdWARE fOR STEP 2 :
BOLT (D) SPRING WASHER (B) FLAT WASHER (E)
20 mm 8.2 mm 8.2 mm
Qty: 6
Qty: 6 Qty: 6
BOLTS (D)
SPRING WASHERS (B)
FLAT WASHERS (E)
CONSOLE MAST CAP
CONSOLE (upside down)
Open hardware for step 2.
A
With the console upside down, attach the
B
console mast caps to the console
using 6 bolts (d), 6 spring washers
(b) and 6 flat washers (e).
8/31/11 1:40 PM
11