Connecting An Ipod - AFG 7.1AT Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONNECTING AN IPOd

®
OR IPHONE
This console includes a built-in iPod cable as an entertainment solution for your workouts. Various iPod and iPhone models with
a dock connector will work with the included iPod cable. iPhone must be set to Airplane Mode to use the iPod cable. iPod and
iPhone models are sold separately.
TO CONNECT yOUR COMPATIblE dEVICE:
1) Plug in your device by matching the dock
connector pin on the iPod cable with the
dock connector on your device NOTE:
Once you have connected the device to
the cable, please allow 10 seconds for it to
authenticate the device before it will be fully
functional.
2) You can use your device's controls to adjust
volume and song settings. Or you can adjust
your volume and song settings using the
iPod control keys on the console. NOTE: If
you don't want to use the speakers, you can
plug your headphones into the audio out
jack at the bottom of the console.
3) Once the device is plugged in you can feed
the cable through the iPod cable channel if
you want to rest the device horizontally. It is
recommended that you rest your device in
the center of the console against the rubber
grip areas.
NOTE: Audio will not play through speakers
if audio adaptor cable is plugged in while the
iPod cable is connected to your device.
30
71AT_OM_Rev1_6.indd 30-31
®
IPOD /
IPHONE
AUDIO IN JACK FOR
IPOD
IPOD CABLE
OTHER MEDIA PLAYERS
CABLE
CHANNEL
AUDIO OUT JACK
IPOD
®
CONTROLS
iPod
®
Controls
Menu
Select
REAdy
REQUIREMENTS
Connect your Nike Plus-compatible
Nike Plus-compatible iPod or iPhone (See www.apple.com/nikeplus for more information).
device to the built-in Made for iPod
connector on Nike + iPod compatible
Before syncing your Apple device to your computer, you must first create a free Nike Plus account at
fitness equipment.
www.nikerunning.com and download the latest iTunes software (www.apple.com/itunes).
SET
Full console controls and built-in
GETTING STARTEd
SonicSurround
speakers make
1) Before connecting your Apple device to the treadmill, you must first turn on Nike Plus on the
it easy to exercise to your favorite
device.
workout playlist.
2) Dock your Apple device and wait for authentication to complete. This may take up to 10
GO
seconds. After authentication is complete, your iPod-specific console controls will be active
Start walking or running. Your pace,
(see next page).
distance, time, and calories burned
3) See Console Operation on page 17 and start your workout.
are recorded as you go. It's all
automatically saved on your iPod or
4) If your iPod or iPhone is Nike Plus compatible, your workout will begin recording
iPhone.
automatically to your Nike Plus compatible device. The console will display, "RECORDINg
WORKOUT TO IPOD. "
SyNC
5) When your workout is complete, the display will verify by displaying "CONgRATULATIONS
When you're done with your workout,
WORKOUT RECORDED. CONNECT YOUR IPOD TO YOUR COMPUTER AND SEE
connect your iPod or iPhone to your
YOUR WORKOUT AT NIKEPLUS.COM. " If you happen to stop your workout before your
computer. iTunes syncs your workout
workout is complete, press and hold stop for 5 seconds. This will record your data to your
data to nikeplus.com. Every workout
Nike Plus-compatible device.
and every run is there, ready for you
to review.
6) Remove your Nike Plus-compatible device and sync with iTunes.
7) Log into your Nike Running account to review and track your workouts.
"Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by
the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance
with safety and regulatory standards. iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
31
8/31/11 1:40 PM

Publicité

Table des Matières
loading

Table des Matières