Welcome; Getting Started; Resetting The Unit; Preparing The Card Remote Commander - Sony CDX-M50IP Mode D'emploi

Welcome !

Thank you for purchasing this Sony Compact
Disc Player. You can enjoy your boating with the
following functions.
• CD playback
You can play CD-DA (also containing CD
TEXT) and CD-R/CD-RW (MP3/WMA/AAC
files (page 20)).
Type of discs
CD-DA
MP3
WMA
AAC
• Radio reception
– You can store up to 6 stations per band.
CDX-M50IP/M30:
FM1, FM2, FM3, AM1 and AM2
CDX-MR50IP:
FM1, FM2, FM3, MW and LW
– BTM (Best Tuning Memory): The unit selects
strong signal stations and stores them.
• RDS services
– You can listen to FM stations with the Radio
Data System (RDS) in Europe.
(CDX-MR50IP)
• Sound adjustment
– EQ3 stage2: You can choose any one of 7
preset equalizer curves.
– DSO (Dynamic Soundstage Organizer):
Creates a more ambient sound field, using
virtual speaker synthesis, to enhance the
sound of speakers, even if they are installed
low in the door.
• Optional device operation
Various kinds of audio devices can be
connected.
– iPod: iPod connection can be made by the
dock connector cable on the rear of the unit.
(CDX-M50IP/MR50IP)
– Portable audio device: An AUX input
jack on the front of the unit allows connection
of a portable audio device (analog
connection).
– CD/MD changers: CD/MD changers can be
connected to the Sony BUS at the rear of the
unit.
6
Label on the disc

Getting Started

Resetting the unit

Before operating the unit for the first time, or
after replacing the boat's battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ball-point
pen.
RESET
button
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Preparing the card remote
commander
Before using the card remote commander for the
first time, remove the insulation film.
Tip
For how to replace the battery, see "Replacing the
lithium battery of the card remote commander" on
page 20.

Setting the clock

CDX-M50IP/M30:
12-hour indication
CDX-MR50IP:
24-hour indication
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until "CLOCK-ADJ" appears.
3
Press (SEEK) +.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press (SEEK)
–/+.
5
Press the select button.
The setup is complete and the clock starts.