Preparing Hot Water - Siemens TK 91 N 01 Notice D'utilisation

● Place the Nespresso-capsule on the
lit balcony 16, with the membrane
downwards (Fig. 2).
● Press the button
An optimum mix of frothed milk and coffee
will now automatically flow into the cup.
Info: You can halt the dispensing of milk or
coffee respectively at any time by pressing
the button (Cappuccino) or
c
macchiato).
Permanently changing the
quantity of liquid
The preset quantity of milk and coffee for
the preparation of cappuccino and latte
macchiato can be changed.
● Prepare the appliance with milk and
coffee.
● Keep the button
(latte macchiato) depressed until the
desired quantity of milk has been fed
through. During this time
or
Cappuccino
Release the button
(Latte macchiato), and the appliance will
steam briefly.
● Now keep the button
or (Latte macchiato) pressed until the
d
desired quantity of coffee has been fed
through. During this time
or
Cappuccino
As soon as the process is completed, the
display indicates
Info: If the quantity of coffee is to remain
unchanged, the procedure can also be
ended after changing the quantity of milk.
● Press button (Stand by).
a
appears in the display.
(latte macchiato).
d
(latte
d
(cappuccino) or
c
Macchiato
flashes in the display.
(Cappuccino) or
c
(Cappuccino)
c
Macchiato
flashes in the display.
.
Ready
Ready

Preparing hot water

This function enables hot water to be
prepared, e.g. for a cup of tea.

Danger of skin burns
!
The nozzle becomes very hot, and
should only be grasped by the plastic
section.
● Screw the nozzle 10 onto the adapter 8 of
the steam pipe 7 (Fig. 3).
● Hold a glass or cup under the nozzle 10.
● Press button
Hot water is dispensed from the nozzle
10.
● To stop, press the button
again.
appears briefly in the display.
Wait
The display then indicates
more.
Heating liquids with
d
steam

Danger of scalding
!
Steam is very hot, and may cause the
liquid to splutter.
d
● Screw the nozzle 10 in place (Fig. 3).
● Press the steam button
and
Steam
display.
As soon as
alternately in the display, steam can be
drawn off.
● Immerse the nozzle 10 deeply into the
liquid, making sure it does not touch the
bottom of the vessel.
● Press button
● Slowly trace circles through the liquid in
the vessel. The liquid is heated up.
● As soon as the liquid is hot, press button
(steam) once again.
h
The display alternates between
.
ready
The appliance now automatically cools
down for around 2 minutes. The display
once again indicates
(hot water).
g
g
Ready
.
h
flash alternately in the
wait
and
Steam ready
(steam).
h
.
Ready
en
(hot water)
once
flash
and
Steam
17