Preparing Hot Water - Siemens TK 53 Série Mode D'emploi

en
Changing volume
dispensed
The pre-set quantities for dispensing button
E
3 (approx. 40ml) and dispensing button
F
4 (approx. 125 ml) can be changed.
● Press and hold the coffee dispensing
E F
button 3 or 4
volume of coffee has been delivered
(range approx. 30 – 220 ml).
i
The quantity can be changed again at
any time. By pressing "Reset", the factory
settings are restored.
Reset: The appliance must be ready for
use.
● Pull out trays 17 and 18. Press and hold
dispensing buttons 3
same time for at least 5 seconds.
● The LEDs 7a, b, c and d (
flash briefly as confirmation.
● Reinsert trays 17 and 18.
The standard factory settings have now
been reactivated.

Preparing hot water

The appliance must be ready for use.
This function allows water to be heated for
a cup of tea, for example.
¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
● Place an appropriate cup under the
nozzle 8.
● Push the sleeve on the nozzle 8 all the
way down.
● Turn the dial 6 to
¡
Risk of scalding
When the dial is set to
may sputter a little. Do not touch the nozzle
8 or point it at anyone.
● End the process by turning the dial 6
back to "O".
20
until the desired
E F
and 4 at the
H I S
, , ,
g h
/ .
g h
/ , the nozzle
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk first and add the coffee
on top, or foam the milk separately and
pour it into the coffee.
¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
● Push the sleeve on the nozzle 8 all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
start to flash.
i
The appliance will heat up for approx.
20 seconds.
● Immerse the nozzle 8 deep into the milk,
but do not let it touch the bottom of the
J
) cup.
● As soon as the LED
rotary button 6 to
¡
Risk of scalding
When the dial 6 is set to
8 may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle 8 or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial 6
back to "O".
i
To foam more milk, press the steam
h
button
process.
Note: When the nozzle 8 has cooled down,
clean immediately. Dried residue is difficult
to remove.
Tip: If possible, use cold low-fat (1,5 % fat)
milk.
h
. The LED will
J
lights up, turn the
g h
/ .
g h
/
again and repeat the whole
, the nozzle