Siemens TK 53 Série Mode D'emploi page 21

Controls
1 Power switch auto off
The auto off power switch can be used to
turn the power supply on or off.
After switching on the power supply, the
appliance heats up, rinses and is then
ready for use. The dispensing buttons 3
F
and 4 both light up.
The appliance does not rinse if it is still
warm when switched on.
If the appliance is not manually switched
off, it will switch off automatically after
approx. 10 minutes after the last dispens-
ing operation and then rinse. The pre-set
switch-off time can be changed (see section
"Automatic Switch-Off auto off").
The appliance will not rinse if:
● there was no coffee drawn after switching
on the machine.
● steam was drawn shortly before switching
off the machine.
● only hot water or steam were drawn.
2 Coffee strength button
By pressing the button
strength can be set:
â
LED does not light = Normal setting
â
LED lights = Strong setting
â
LED flashing = Bean container empty
3 Dispensing button
With this button, a small cup (approx. 40ml)
of coffee can be dispensed.
● Press the button 3
to flash. The coffee is ground, brewed
and poured into the cup. Both LEDs light
up as soon as the process is finished.
The beverage size can be changed (see
section "Changing volume dispensed").
â
â
, the coffee
E
Small coffee
E
. The LED will start
4 Dispensing button
With this button, a large cup
(approx. 125ml) of coffee can be dispensed.
● Press the button 4
to flash. The coffee is ground, brewed
and poured into the cup. Both LEDs light
up as soon as the process is finished.
E
The beverage size can be changed (see
section "Changing volume dispensed")
5 Steam generation button
The steam button
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
steam, the steam generation button
must be pressed first (see "Steam for foam-
ing milk").
7 LED display
The various LEDs indicate the following:
H
on
I
on
I
flashing
S
on
S
flashing
J
on
J
flashing
F
Large coffee
F
. The LED will start
h
h
generates steam for
g h
or . To dispense
The water tank is empty and
needs to be filled
Trays full:
Empty and replace them
T rays missing:
Reinsert them
Run the service programme
(see "Service programme")
S ervice programme in
operation
g h
Turn dial to /
Turn dial to "O"
en
h
17