Siemens TK 91 N 01 Notice D'utilisation page 26

en
Messages in the display
and
Please fill water
flash alternately in the display
and
Empty capsules
alternately in the display
and
Check container
alternately in the display
The display shows
save
Visual alert
The float in drip tray 11 or 12
repectively becomes visible.
What if something goes wrong?
The blue illuminated ring 1b
does not light up.
It is impossible to heat water
or generate steam.
Not enough milk froth is being
produced, or it is too runny.
Message in display
Please fill water
despite a full water tank
22
The water tank 5 is empty.
Fill it with fresh water.
Press button
a cup.
Ready
The capsule container 13 is full.
flash
Dispose of the used Nespresso® capsules (Fig. 6).
The drip tray 12 and the capsule container 13 are
flash
missing.
Put the drip tray 12 and the capsule container 13 back
into position.
The appliance automatically switches to power save if
Power
it has not been used for an hour.
During the rinsing procedure, when preparing coffee
and drawing steam, a certain amount of water will
collect in the drip trays. As soon as these are full, the
float rises (Fig. 6). Once the float becomes visible, the
corresponding drip tray must be emptied.
● Remove the small drip tray 11
● Pull the large drip tray 12 forwards.
● Remove the capsule container 13.
● Empty the drip trays and clean them using a little
detergent solution.
● Mount the capsule container 13 on the large drip tray
12, and push back into position.
● Insert small drip tray 11.
Check the power supply (possible power outage) and
that the ON/OFF switch 17 is set to I.
Nozzle 10 is blocked up.
Clean nozzle 10 using a detergent solution and a
blunt needle.
● The frothing attachment 9 is blocked. Wash with a
mild detergent solution, as directed.
● Use cold milk with a fat content of at least 1.5 %.
After the water tank has been filled, no coffee has yet
been served.
Press
(small cup) and allow water to run into
e
appears in the dispay again
(hot water).
g