Preparing Coffee - Siemens TK 91 N 01 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Water hardness
The preset water hardness is 3.
To determine the hardness of the water in
the area, use the test strips provided, or
make inquiries with the local water utility.
To change the water hardness setting,
consult the section "Changing basic
settings".
Power save
The appliance automatically switches to
economy mode if it is not used for an hour.
The display shows
This function can be activated and de-
activated as desired via the basic settings.
Info: The warming plate 3 is not switched
off in economy mode.
Every time the cold appliance is switched
on,
appears in the display.
Rinsing
The appliance is rinsed automatically. If
has been selected in the basic
Manual
settings,
Launch rinsing cycle
appear in the display.
Check that all drip trays are in place, and
then press the button
appliance is rinsed.

Preparing coffee

Tip: For really successful espresso coffee,
preheat the cups on the warming plate 3, or
fill the cups with hot water and empty out.
The appliance must be switched on, and
showing in the display. If window
Ready
2 is closed, move your hand in front of the
window to open it (Fig. 2).
● Place a Nespresso capsule on the
lit balcony 16, with the membrane
downwards (Fig. 2).
● Place a preheated cup under the coffee
dispenser 14.
.
Power save
will
(large cup). The
f
● Depending on the cup size required,
press button
(small cup) or button
e
(large cup). The cup is filled. The coffee
dispenser automatically cuts off as soon
as the programmed quantity has been
served.
appears in the display.
Ready
Info: After use, the capsule is automatically
ejected into the capsule container 13.
Info: Approx. 2 min. after the brewing
process has finished, the window closes
automatically. The appliance is equipped
with a sensor which automatically opens the
window in response to a hand movement.
To stop the flow of coffee prematurely
● Press button
(small cup) or button
e
(large cup) once again.
To change the quantity of liquid
permanently
The preset quantity for a small and large
cup respectively can be altered.
● Keep the button
(large cup) depressed until the desired
f
quantity of coffee has been served.
During this time, the text in the display will
flash.
Info: The quantity can be changed at any
time.
Additional quantity of liquid
● Press button
(small cup) or button
e
(large cup) again, within four seconds of
the flow of coffee stopping.
The same quantity of water again will be
passed through the capsule.
To prepare coffee or obtain water
immediately after drawing off steam
If immediately after drawing off steam,
coffee is dispensed by pressing the button
(small cup) or button
e
appliance initially cools off automatically.
The appliance first gives off steam at
intervals, then coffee flows from the coffee
dispenser 14.
(small cup) or button
e
(large cup), the
f
en
f
f
f
15

Publicité

Table des Matières
loading

Table des Matières