Storing The Appliance - Black & Decker BXAC12000E Manuel D'utilisation

Once the appliance has been used:
♦ Stop the appliance by pressing button (A1) on/off
♦ Unplug the appliance from the mains.
♦ Unplug the appliance from the mains and allow it to cool
down before starting any cleaning operation.
CLEANING
♦ Wipe the appliance with a damp cloth impregnated
with a few drops of detergent. Do not use solvents or
products with an acidic or basic pH factor such as bleach
or abrasive products to clean the apparatus.
♦ Do not immerse the appliance or its plug in water or
other liquid or place it under the tap.
♦ If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance's useful life and could become unsafe
to use.

Storing the appliance:

♦ Switch off the appliance and remove the plug.
♦ Separate the exhaust pipe from the air and store it
carefully.
Problem
Product is not working
Seems device is not working
Devide noise too loud
Compressor is not working
Detection codes
E1/E2:
FL:
Causes
There is no current.
Illuminated water fill indicator
Windows or doors are open
Dirty filter
Air inlet or outlet are block
Room temperature is lower than the
programated
Device is not in a flat surface
Overheat protection is activated
Meaning
Temperature sensor problem
Water tank full
(Original instructions)
♦ Put the appliance in a dry place.
♦ Remove the batteries from the remote control and store
them carefully.
ANOMALIES AND REPAIR
♦ In the event of a fault, take the appliance to an author-
ized service center. Do not attempt to disassemble or
repair it as there may be danger.
♦ Any person who is involved with working on or breaking
into a refrigerant circuit should hold a current valid certif-
icate from an industryaccredited assessment authority,
which authorizes their competence to handle refrigerants
safely in accordance with an industry recognized assess-
ment specification.
♦ Servicing shall only be performed as recommended by
the equipment manufacturer. Maintenance and repair
requiring the assistance of other skilled personnel shall
be carried out under the supervision of the person
competent in the use of flammable refrigerants.
♦ If any fault is detected, refer to the following table:
Solutions
Switch on device
Empty water tank
Start device after empty water tank
Close doors
Close windows
Clean or change air filter
Clean container
Change temperature setting
Change device in a flat surface
Switch on device after 3 minutes, when
temperature is lower
ENGLISH
9