Regulatory Information - Johnson Controls tyco 3G4000W Manuel D'utilisation

2. Only use RM-2, the power supervision relay, when the control panel is not powering the
3G4000W. When the control panel is powering the Radio the relay is not required since a loss of
input power generates a signal to the CMC.
3. Ensure to set output 2 on the 3G4000W to its default setting, Active Low.
4. You can use a zone input on the control panel to monitor if the 3G4000W has lost power.
Connect it in accordance with Figure 4.

Regulatory information

End user license agreement
Modification statement
Digital Security Controls has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user's authority to operate the equipment.
Digital Security Controls n'approuve aucune modification apportée à l'appareil par l'utilisateur, quelle
qu'en soit la nature. Tout changement ou modification peuvent annuler le droit d'utilisation de l'appareil
par l'utilisateur.
Interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Wireless notice
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The antenna should be installed and operated with minimum distance of 30 cm between the radiator and
your body. Antenna gain must be below:
3G4000W frequency band
Frequency band
GSM 850
GSM 900
DCS 1800
PCS 1900
WCDMA B5, WCDMA B8
WCDMA B1 (Tx), WCDMA B2
WCDMA B1 (Rx)
FCC Class B Digital Device Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
46 3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0
3G4000W
2.5 dBi
2.5 dBi
6.2 dBi
6.2 dBi
2.5 dBi
6.2 dBi
2.8 dBi