Johnson Controls tyco 3G4000W Manuel D'utilisation page 30

[422] – [11] – Supervision Trouble Reporting: Default (Enabled)
This option determines whether the Supervision Trouble reporting code is communicated or
suppressed.
[422] – [12] – Supervision Trouble Restore Reporting: Default (Enabled)
This option determines whether the Supervision Trouble Restore reporting code is communicated
or suppressed.
[422] – [13] – Firmware Update Start Reporting: Default (Enabled)
This option determines whether the Firmware Update Start reporting code is communicated or
suppressed.
[422] – [14] – Firmware Update Fail Reporting: Default (Enabled)
This option determines whether the Firmware Update Fail reporting code is communicated or
suppressed.
[422] – [15] – Firmware Update Successful Reporting: Default (Enabled)
This option determines whether the Firmware Update Successful reporting code is communicated
or suppressed.
[702] – Communications Format: Default (Unknown)
This status indicates whether the 3G4000W communicator has detected if the control panel is using
the SIA or Contact ID reporting formats to communicate signals.
[906] – Radio Reset Codes:
This status field contains a history of radio resets and the reasons why they occurred. This field
may be used by JCI Technical Support to diagnose network connectivity issues. This is a read-only
section.
[907] – Current Receiver:
This status shows which of the central station receivers the product is presently using for
communications. This is a read-only section.
[908] – Cellular Network Provider:
The network provider name is derived by the Mobile Country Code (MCC) and Mobile Network Code
(MNC). The 3G4000W DLS software will attempt to show the cellular network provider's name, if
available. For example, Movistar, Claro or Entel.
[909] – Cellular Network Type:
This status indicates whether the 3G4000W is currently attached to a 2G or 3G network.
[910] – Cellular Network CSQ:
This status indicates the signal strength of the device, where 00 is no connectivity or measurable
signal strength, and 31 is the maximum measured received signal strength.
[911] – Radio Manufacturer ID:
This status indicates the manufacturer of the radio module. The 3G4000W communicator indicates
Telit in this field.
[912] – Radio Type:
30 3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0