Enerzone Solution 3.5 Manuel D'installation Et D'utilisation page 171

Report prepared for: Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on 9/6/2018 2:01:07 PM
GENERAL REQUIREMENTS AND DEFINITIONS
Accepted - Accepted by Intertek. All inquiries regarding change to Listed products must be
presented to Intertek in writing for consideration and acceptance.
Applicant – The term Applicant shall mean the company who submitted the product for evaluation
and certification and owns rights to Listing Reports.
Authorization to Mark - The term Authorization to Mark ("ATM") shall mean a written document
from Intertek that authorizes the Manufacturer to apply an Intertek certification mark to a specific
product.
Authorized - Authorized by Intertek. All inquiries regarding change to Listed products (or
systems?) must be presented to Intertek in writing for consideration and approval.
Certification Agreement – An agreement executed between Intertek and the Applicant, and, when
applicable, between Intertek and the Manufacturer setting forth the terms and conditions for Listing,
Labeling and Follow-up Services provided by Intertek.
Certified - Material or assembly included in a list published by a nationally recognized certification
agency that conducts periodic inspections of production of Listed materials or assemblies and
whose listing states either that the material or assembly meets recognized standards or has been
tested and found suitable for use in a specified manner. See also Listed.
Discrepancy or Variance - A difference between the Listing Report and a product or procedure
described in the Listing Report. This will result in the filing of a Variance Report on which a
management level decision for the corrective action will be based.
Installation, Operating and Safety Instructions - Instructions for installation and use of the
product or system are provided by the Manufacturer.
Listed - Materials or assemblies included in a list published by a nationally recognized certification
agency that conducts periodic inspections of production of listed materials or assemblies, and
whose listing states either that the materials or assemblies meets nationally recognized standards,
or has been tested and found suitable for use in a specified manner. See also Certified.
Listed Component - Identifies any product that is a component of the Intertek Listed product or
system that is covered under the Listing or Certification service of another certification body.
Manufacturer - The term Manufacturer shall mean the company who carries out or controls certain
stages in the manufacture, assessment, handling, and storage of a product that enables it to
accept responsibility for continued compliance of the product with the relevant requirements and
undertakes all obligations to apply the certification labels.
Markings - The Intertek Certification Mark shall be visible after installation. Other markings may be
required as identified in this Report. If evaluated to a Canadian standard, the products may be
required to have markings in both French and English. If so, it is the responsibility of the Applicant
to determine any such requirement and provide bilingual markings, where applicable, in accordance
with the Canadian Provincial Regulatory Authorities.
Stove Builder International Inc. | 44826 | Rev: Aug 31 2018 3:17PM | Uncontrolled Copy Page 179 of 201