Enerzone Solution 3.5 Manuel D'installation Et D'utilisation page 149

Report prepared for: Guillaume Thibodeau-Fortin (Stove Builder International Inc.) on 9/6/2018 2:01:07 PM
Test report 103536746MTL-002 (2 of 21)
TEST REPORT FOR STOVE BUILDER INTERNATIONAL INC.
Report No.: 103536746MTL-002
Date: 07/13/18
REPORT ISSUED TO
STOVE BUILDER INTERNATIONAL, INC.
250 de Copenhague
ST-Augustin-de-Desmaures, Qc, G3A 2H3
SECTION 1
SCOPE
Intertek Testing Services NA (Intertek) has conducted testing for Stove Builder
International Inc., on model Solution 3.5 Series Wood Burning Room Heater to evaluate
all applicable performance requirements included in "Determination of particulate matter
emissions from wood heaters."
The test was conducted to determine if the unit is in accordance with U.S EPA
requirements under EPA 40 CFR Part 60 "Standards of Performance for New Residential
Wood Heaters, New Residential Hydronic Heaters and Forced-Air Furnaces". This
evaluation was conducted on May 22
were applicable:
Testing was performed by the undersigned at client's facility.
This report does not constitute certification of this product nor an opinion or endorsement by
this laboratory.
Version: 05/10/17
Stove Builder International Inc. | 44826 | Rev: Aug 31 2018 3:17PM | Uncontrolled Copy
nd
ASTM E2515-11- Standard Test Method for Determination of Particulate Matter
Emissions Collected by a Dilution Tunnel
ASTM E3053-17 - Standard Test Method for Determining Particulate Matter
Emissions from Wood Heaters using Cordwood Test Fuel. It is based on the
ALT-125 send by EPA on February 28
CSA B415.1-10 - Performance Testing of Solid-Fuel-Burning Heating Appliances
Page 2 of 21
Telephone: 608-836-4400
www.intertek.com/building
th
to May 25 2018. The following test methods
th
, 2018.
8431 Murphy Drive
Middleton, WI 53562
Facsimile: 608-831-9279
GFT-OP-10c
Page 157 of 201