EHEIM Professionel 2226 Mode D'emploi page 15

Press the first one down to the support frame and be sure that
the following media containers have a flush fit. In the process,
the pipe openings of the media containers must lie on top of
each other and the rubber seals must be correctly fitted on
the openings so as to achieve a hermetic seal.
Insert a new filter pad and cover it with the lattice screen.
ATTENTION: Fine filter pad (white) should not be placed
under the retractable handle of the media container.
Check to ensure that the sealing gasket of the pump head fits
properly and is clean.
Then lightly lubricate the sealing gasket of the pump head
with Vaseline. Place the pump head on the filter canister,
close the EZ clips and place the filter into the cabinet.
Note: All hose connections must be checked at regular inter-
vals for correct fitting.
Safety instructions
For indoor use only. For aquaristic applications.
Before placing your hand in the aquarium water, ensure
that all electrical appliances in the water have been
switched off at the mains.
The mains cable of the device cannot be replaced. If the
cable has been damaged the device must no longer be
used.
Contact your specialized dealer or your EHEIM Service
Centre.
This equipment is not intended for use by persons (in-
cluding children) with limited physical, sensory or mental
abilities or for persons with no experience or knowledge
unless they are supervised by a person responsible for
safety or unless they have received from such a person
instructions on how to use the equipment.
Children should be supervised to ensure that they do not
play with the equipment.
Do not dispose of this product as normal household
waste. Take it to your local refuse collection site.
For your own safety we recommend that you allow the mains
cable to form a drip loop which ensures that water running along
the cable cannot drip into the mains socket.
If a multiple socket is used this must be placed above the mains
connection of the filter.
The products are approved according to the relevant
national rules and regulations and are in accordance with
EU standards.
11
Examine all three O-rings on
the double tap connector for
damage and correct fitting
and lightly grease them with
Vaseline; insert and lock in
place.
After both of the tap levers
on the integrated double tap
connector have been open-
ed (position ON), the filter
will automatically fill up again
with water and will be ready
for operation.
Set the filter into operation
by connecting the mains
plug.
GB