Publicité
Les langues disponibles
Les langues disponibles
Close the open side of the spray bar with the enclosed
end cap.
TIP: The spray bar can either be installed below water level
or just above the surface, depending on whether you wish
to have oxygen-rich surface movement or not.
TIP: If you lay the tubing into warm water for some time
beforehand, they will become soft and possible kinks can
be easily squeezed out.
Attach the intake strainer to
the intake tube and fasten it
onto the interior glass of the
tank with two clips and suc-
tion cups.
Connect the security outlet
pipe and spray bar with a
short piece of tubing and
install in the aquarium with
the clips and suction cups.
Place on the rear or on one
of the sides of the tank,
depending on available di-
mensions.
Guide the hoses from the
filter outwards, through the
opening in the aquarium ca-
binet, and connect the in-
stalled intake pipe and out-
put pipe according to the
respective tubing diameters.
To achieve an even flow, be
sure that the tubing is laid
out smoothly and has no
kinks; if necessary, shorten
them.
Setting into operation
Open the taps of the inte-
grated double tap connec-
tor by shifting both levers
to position ON. Separate the
output hose from the spray
bar and suck strongly on the
hose, to establish the sy-
phon.
TIP: Alternatively use the
EHEIM Universal Installation
Kit 1 (diameter 16 mm, order
no. 4005300) or the suction
device (order no. 4003540).
The canister will then auto-
matically fill up with water.
Reconnect the hose to the
spray bar.
Nr. 4003540
Once again check all the connections for watertightness.
Then set the filter into operation by connecting the mains
plug of the pump head.
Note: The water flow from the pump can be controlled by
using the tap only on the pressure side (OUT).
ATTENTION: Never reduce the pump output by closing
the tap on the suction side (IN).
9
IN
Nr. 4005300
IN
GB
Publicité
