Pt 40 Flexx Bodypack Transmitter; Controls - AKG WMS 40 FLEXX Mode D'emploi

Note:
2.6 P P T 4 4 0 F F LEXX
Bodypack T T rans s m m it t t t e e r r
2.6.1 C C ontrols
Refer to fig. 4 on page 2.
Note:
26
2 Description
LED lit red: From the moment the LED changes to red, the battery
capacity will provide a maximum of two operating hours. We recom-
mend replacing the battery with a new one as soon as possible.
• If you use a rechargeable battery, the LED will change to red 15 min-
utes before the battery will be dead!
17 Frequency selector: This slide switch tunes the transmitter to one of
three different carrier frequencies within the transmitter's carrier fre-
quency band.
18 GAIN: This slide switch sets the transmitter's audio input gain in two
stages, "HIGH" (high gain) or "LOW" (low gain).
19 Color code clip: The color of this plastic clip indicates the carrier fre-
quency band of your transmitter. Re ceivers tuned to the same fre-
quency band are marked with the same color. Refer to the Manual
Supplement sheet for a color code table.
You can remove the color code clip on the HT 40 FLEXX and replace
it with the supplied semitransparent clip.
20 Battery compartment lid: Refer to section 3.5.
21 Carrier frequency label: The label above the battery compartment
indicates the name of the carrier frequency band and the three carrier
frequencies of your transmitter.
You can use the PT 40 FLEXX bodypack transmitter with both dynamic
microphones and condenser microphones designed for a supply voltage
of approx. 4 V. You may also connect an electric guitar, electric bass, or
remote keyboard.
Operating in the 660 MHz to 865 MHz UHF range, the PT 40 FLEXX provides
three selectable, quartz stabilized carrier frequencies within the 3-MHz-wide
frequency band for which you ordered your WMS 40 FLEXX.
22 On/off switch: This slide switch provides three positions:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted
while power and the RF carrier frequency remain on.
OFF: Power to the transmitter is off.
23 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery
capacity will provide a maximum of two operating hours. We recom-
mend replacing the battery with a new one as soon as possible.
• If you use a rechargeable battery, the LED will change to red 15 min-
utes before the battery will be dead!
24 Audio input: 3-pin mini XLR connector with both mic and line level
pins that automatically match the connector pinout of the recom-
mended AKG microphones or MKG L guitar cable.
While the MKG L guitar cable is included in the Instrumental Set (see
section 2.2 Unpacking), it is also available as an optional accessory.
25 Frequency selector: This slide switch tunes the transmitter to one of
three different carrier frequencies within the transmitter's carrier fre-
quency band.
26 Antenna: Permanently connected, flexible antenna.
27 Belt clip for fixing the transmitter to your belt.
28 Battery compartment lid with integrated screwdriver (28a).
AKG WMS 40 FLEXX