Removing The Charger; Contact Information - EUFAB 16615 Mode D'emploi

Masquer les pouces Voir aussi pour 16615:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Error messages
Display of error after faulty connection (wrong poles), short-circuit, selection
of an incorrect charging programme or overheating.
Error message if a battery with less than 5.5 V ± 0.2 is connected or if the
voltage is still below 6 V after 4 h charging time.

Removing the charger

First pull the plug out of the socket and observe the sequence for disconnection. This prevents sparks
from forming. Since charging generates a detonating gas, this is particularly important for the sake of
your safety.
Disconnect the charger from the mains power supply.
Then disconnect the black callipers (minus). Then remove the battery callipers from the plus pole of the
battery (red callipers).
Allow the battery to cool and fill the cells with distilled water to the filling level named by the battery
manufacturer. Close the battery cells using the caps.
Maintenance and care
Maintenance: If used correctly, the device is maintenance-free.
Care: Clean the pole callipers every time the charging procedure is completed. Remove all splashed battery acid
from the pole callipers to prevent corrosion. Clean the device carefully with a dry cloth. Do not use liquids or chemi-
cal cleaning agents. Never submerge the device in liquids. Never allow liquid to flow over the device.
Before storing the device, roll up the cables properly using the designated hook in order to prevent damages to the
cables and device. Store the device in a clean and dry place.
Notes regarding environmental protection
The packaging is made up of environmentally friendly materials which may be disposed of via your local
recycling points.
Do not put electrical devices into the household waste. Electronic and electrical devices must be
collected separately and sent for environmentally friendly recycling. Contact your community or town
administration for information regarding the disposal of electrics.

Contact information

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
9

Publicité

Table des Matières
loading

Table des Matières